BOHNING TOWER FLETCHING JIGS
The Tower® reduces your fletching time to a third, increasing arrow production and providing the easiest and most precise 3-vane placement 120° apart. The Tower® accommodates all size arrows from small carbon X10s up to Fat Boys (note that the Crossbow Tower® fits .2985 and .303 bolts). Every Tower® includes clamp release tape and 2 collar rings: red for use with small carbon up to aluminum shafts, and green for use with fat boy shafts. All Tower® System arms are compatible with the Tower® Jig base, no need to purchase additional jigs for Impulse™ and Crossbow applications! Replacement or additional arm sets are sold separately.
Impulse™ Tower® Fletching Jig includes:
• Standard Post, Pin-Nock Post and F-Nock Post
• 1 set of arms specifically designed for the thinner material of the Impulse™
• The maximum vane size for fletching is 4”
Helix Tower:
The most precise jig on the market. Place 3 vanes perfectly 120 degrees apart with one flip of the lever! This jig will fletch almost any size shaft with press fit nock removed, pin nock removed from pin, or crossbow bolt. Fletches 3 vanes at one time up to 2.25 inches in length on a 3° right helical. Helix Tower includes 5 center post options: Standard Carbon(.240 id), A-Nock(.201 id), F-Nock(.164 id), Xbow Bolts, and pin nocks
Feather Tower:
Standard Post, F-Nock Post, Swedged End Post
• 2 sets of arms: blue for Right Wing 1° helical, green for Left Wing 1° helical
• The maximum feather size for fletching is 5”
Triple Tower:
The Triple Tower® is a fletching system that accommodates all size arrows from small carbon X10s up to Fat Boys and allows you to fletch 3 vanes at once precisely 120° apart, and reduces your fletching time to a third! Includes 5 interchangeable center posts to accommodate Standard nocks, Pin nocks, F nocks, A nocks and Crossbow nocks. Two collar rings are included: red for use with small carbon up to aluminum shafts, green for use with fat boy shafts. The Triple Tower® includes clamp release tape and 3 sets of 'arms': black arms for a 3° right helical, red arms for a 2° right offset, and gray arms for straight fletchings. The maximum vane size for fletching is 2.25" for Helical, and 4" for Offset or Straight. The Tower® is not for use with swedged end shafts or feathers. The Tower® saves time, increases arrow production and provides the easiest and most precise vane placement!