Easton XX75 Platinum plus arrows (6 per set)
SKU:
€44.00
€44.00
per item
PLEASE NOTE: If you require screw in points and inserts, please select "Not Required" in the point section, add the inserts and points you want to your order and then email us to let us know they need fitting to the arrow. (Please include order number in email)
XX75 Platinum provides top-quality aerospace alloy consistency and performance that comes in a full range of sizes for almost any target shooter. Get Platinum for easy set up, quick bow tuning, and super tight groups. Straightness: ± .002 Weight tolerance: ± 2.0 Hard–anodized Alloy
Additional notes regarding nock fitting.
Shaft sizes up 1516 through 1916 use 'G nock' fitting.
Sizes 2013 and above use 'Super nock' fitting.
Please Note Maximum stock lengths :-
1416 = 27"
1516 = 27.5"
1616 = 28.5"
1716 = 29"
1816 = 30"
1916 = 31"
2016 = 32"
1713 = 29"
1813 = 30"
1913 = 31"
2013 = 32.5"
2213 = 32.5"
2114 = 32.5"
2315 = 34"
We will gladly cut your arrows/shafts to size, but please note the following.
1) The industry standard (AMO) method of measurement is from the bottom of the nock groove to the end of the shaft.
2) Our cutting tolerances are +- 1/16” with appropriate nock combination.
If you require anything different from the above, we will be pleased to accommodate you. But you must email us for instructions before ordering.
We can do most things, but we can’t put the end back on an arrow!
XX75 Platinum provides top-quality aerospace alloy consistency and performance that comes in a full range of sizes for almost any target shooter. Get Platinum for easy set up, quick bow tuning, and super tight groups. Straightness: ± .002 Weight tolerance: ± 2.0 Hard–anodized Alloy
Additional notes regarding nock fitting.
Shaft sizes up 1516 through 1916 use 'G nock' fitting.
Sizes 2013 and above use 'Super nock' fitting.
Please Note Maximum stock lengths :-
1416 = 27"
1516 = 27.5"
1616 = 28.5"
1716 = 29"
1816 = 30"
1916 = 31"
2016 = 32"
1713 = 29"
1813 = 30"
1913 = 31"
2013 = 32.5"
2213 = 32.5"
2114 = 32.5"
2315 = 34"
We will gladly cut your arrows/shafts to size, but please note the following.
1) The industry standard (AMO) method of measurement is from the bottom of the nock groove to the end of the shaft.
2) Our cutting tolerances are +- 1/16” with appropriate nock combination.
If you require anything different from the above, we will be pleased to accommodate you. But you must email us for instructions before ordering.
We can do most things, but we can’t put the end back on an arrow!
